How to use Hyper Terminal or console cable on network

How to use Hyper Terminal or console cable on network.
1.   In this lesson we will learn about using Hyper Terminal or console cable over network. Mostly all network devices are accessed from remote location. All configurations or network management is done by network administrator from remote location. But when device is down that can’t be accessed from remote then it is compulsory to go to device location and configure it from there with the help of hyper terminal.
2.  If we connect with cross over cable or any other Mode then we can’t find Router CLI mode.
For checking router CLI mode Go to PC> Desktop> Terminal > Click OK>Your screen
Hyper Terminal


3.  In below picture we have taken one router that can’t be controlled from remote location. We go to nearby device and connect our PC with console cable with Router. To connect console cable just connect cable with R232 PC port and Router console port. After connecting ports Go to same way :
Go to PC> Desktop Tab> Terminal>Click OK> Your CLI screen.
Hyper Terminal

4.  As you can see above CLI mode is accessed by PC. You can configure it what you want.



4 comments:

  1. TMIS22 April 2020 at 20:08

    Speed Test

    ReplyDelete
  2. sasdads20 December 2021 at 23:23

    You possess lifted an essential offspring..Blesss for using..I would want to study better latest transactions from this blog..preserve posting.. kündigung

    ReplyDelete
  3. Micheal5 April 2025 at 02:34

    Test cables after every new installation. https://www.bridgecable.com/

    ReplyDelete

Subscribe to: Post Comments (Atom)

Upgrade Cisco 9200 switch step by step

Here is a step-by-step guide to upgrading a Cisco Catalyst 9200 switch in Install Mode: Clean up inactive installations : Use the command  i...